This is assuming that you only have ZDoom/GZDoom and ONE Doom WAD file in the same directory The above line is similar to the BAT file needed (All this 'NSIS' and 'Autohotkey' is beyond me), but I can see a problem So what's really needed is a ZDoom/GZDoom PortableApp Launcher or frontend that just start up Zdoom/GZDoom with the necessary 'switches' IF you DON'T supply the 'iwad' switch - GZDoom automatically comes up with a selection list of avaliable WAD's found - for you to choose The PC work however is a slow PC with NO OpenGL graphic card & low res screen etc - so GZDoom uses the 'johnsmith44.ini' which has the settings set lowĪll the 'Save' files are stored in the GZDoom directory UNLESS you run GZDoom with a command switch '-savedir ' and you can (if you're lucky enough to actually OWN the original Doom games) actually run each variation of Doom (doom/Doom II/Ultimate etc) also by using a command switch to load the necessary WAD file ('-iwad '). The PC I use home is a high powered PC with High-res widescreen monitor - so GZDoom will use the 'kermit.ini' file which has all settings set high It decides on which INI to use based on the log-on details of the computer you're on (so if I logon to home computer as 'kermit' it uses 'kermit.ini',if I log on work as 'johnsmith' it will use 'johnsmith.ini') You are right it saves it to an *.ini file - but this is NOT necessary for each user, it's for each Computer you have logged into - which is a good thing surely. I've been using GZDoom (a version of Zdoom but with OpenGl support) on my USB for ages (but NOT through portableapps launchpad - I use PStart instead).
0 Comments
Leave a Reply. |